Your Source for Premium
Vehicle & Watercraft Covers

• Zippered panels allow access to the door, engine and both side storage areas
• Adjustable front and rear tension panels provide a custom-like fit
• Triple layer polypropylene top panel beads water on contact provides maximum resistance to rainfall and snow
• Heavy duty single layer polypropylene sides
• Prevents mold, mildew and ice buildup
• Vent flaps eliminate wind lofting and inside moisture
• Elastic corners for fast and easy fitting
• Tough interlocking seams
• Free storage bag and tie-down rope included
• 5-year warranty

The length of your vehicle is typically located on a slip of paper inside one of the cabinets or in the owner's manual. If the paper and manual are missing you will need a tape measure and one another person to measure your vehicle.

1. Place one end of the tape measure on the edge of the rear bumper. Have a friend hold the end of the tape measure in place.

2. Extend the tape measure and place it on the edge of the front cap.

3. Read the measurement. This is the length of your vehicle.

Note about roof equipment (i.e. air conditioners) and bumper accessories (i.e. tanks): All of our covers are design with enough extra play to fit over roof equipment (i.e. air conditioners) and bumper accessories (i.e. tanks). The cover will simply sit a little higher on the side of your RV where the roof equipment or bumper accessory is located. You do NOT need to add anything to the measurement of your vehicle.

Note about vehicle lengths that are with two part numbers: If you find that two different part numbers include your exact vehicle length, always choose the smaller of the two part numbers. Otherwise the cover will be too large and will not fit properly.

Warning: Installation is best done with two people. Never install on a windy day or when your vehicle roof is wet or icy. Please take care whenever you are on a ladder or the roof.

To install the cover, proceed as follows:

1. Cover any sharp edges on your vehicle with tape that could wear against your cover. Lower any roof antennas.
2. Unroll the cover on the roof of your 5th wheel.
3. Zip all the cover panels closed and pull the elasticized corners down over both bumpers of your 5th wheel.
4. Locate the hook and loop straps on the upper part of the flaps that fold in under the nose of your 5th wheel. Adjust them to fit your cover to the exact length of the nose of your vehicle.
5. Once the length of the nose of the cover is correctly adjusted, locate one of the supplied ropes and the eylets sewn in along the flaps that fold in under the trailer. Tighten the rope and tie it off opposite each other. Repeat with the other side.
6. Adjust the rope length to fit your trailer. Don’t over tighten—the rope should be snug, not drum tight.

Your cover can be unzipped for access to the passenger side and rear. The panels can be rolled up and held in place with the hook and loop straps toward the top of each panel. A handy storage bag is provided. To fit it in the bag fold your cover and roll the cover tightly rather than stuffing it. Never store a wet cover in the storage bag or confined area as the cover can be damaged by mildew.

Please Note! Your cover is for storage only. Do not attempt to travel with the cover on, or partially on. Contact with hot surfaces such as exhaust systems will damage the cover.

Caution! Always take care when walking on the roof of your RV. SafeGuard Covers and our parent company takes no responsibility for accidents or damage resulting from walking on the roof of the RV. Avoid walking on the cover because you may slip and fall. Whenever possible, use two people to install the cover. Do not attempt to install the cover in windy conditions.

Cleaning Instructions: The cover may be cleaned by spraying with a hose and/or using a solution of mild soap and water, and a soft brush. Don’t use abrasive cleaners or harsh brushes. Rinse with hose and allow to dry completely before folding for storage.

Warranty: If this cover fails due to a defect in workmanship and materials within five (5) years from the date of purchase SafeGuard Covers will repair or replace it free of charge. Trailering or towing your 5th wheel with your cover on will invalidate the warranty. This warranty gives you specific rights and you may also have other rights which vary from state to state.